stainless steel label How to Cover Appliances to Look Like Stainless Steel
2019-06-04
stainless steel label How to Cover Appliances to Look Like Stainless Steel
Make your appliance look new by covering a smooth textured white or black surface with bright and shiny faux steel plates.Appliances with tempered glass doors, such as dishwashers, can also be covered with artificial steel plates.While you can go through the time-consuming and confusing process of applying liquid stainless steel to your appliance, a simpler option is to cover them with artificial stainless steel film, so they look like they are covered in stainless steel.Clean the surface of the appliance thoroughly with a sponge and warm soapy water made of soap to remove dirt, grease and dirt.Measure all sides of the appliance you want to cover, and add 1/2 to each measurement.Write these measurements on paper with a pen to track them.Transfer the measurement results, plus an extra 1/2 on all sides, to a thin film of artificial stainless steel with fine point felt --Straight sides of the pen and metal.Place the metal straight edge on the lines you draw on the faux stainless steel film.Cut the film with a tool knife and use the metal straight edge as the cutting guide.Spray the surface of the appliance with a water bottle and wet it.The wet surface will allow the adhesive on the back of the artificial stainless steel film to stick to the device.Place the cut steel film on a flat working surface and the plastic lining on the back of the film faces you.Pull down the first 4 inch of the liner.Keep the pasting side of the steel film in the position facing the front of the appliance, the top edge of the film and the side overlap the top, left and right edge of the appliance.Press the film on the appliance, smooth it with one hand, while keeping the bottom of the film stable with the other hand.Wrap the excess film in a place that overlaps the top right corner of the appliance and the edge of the side.4-pull back slowlyThe inch part of the lining and continue to smooth the film to the surface of the device.Take a moment when you use a liner.Remove any airbag or bubble by running a scraper on the bubble.Push the air bag to the edge of the film and remove it.Run the hair dryer on the lowest setting on the edge of the film, heat it, and help it attach to the surface of the appliance.Wait 24 hours before the movie is fully ready.Cut off the excess film with a tool knife.Rub the cut side to the device with the side of the credit card.
Custom message

Chat Online inputting...