Membrane switch manufacturer introduces installation of sign in several ways

by:ShunDing     2020-09-07
Membrane switch manufacturer introduce installed several ways of sign 1, paste which has been widely applied in this way, the adhesive has a glass glue, AB glue, foam glue, all-purpose adhesive, sponge rubber, double-sided adhesive, chloroform, structural adhesive, etc. To - - - - - - - > membrane switch manufacturer introduce installed several ways of sign 1, paste which has been widely applied in this way, the adhesive has a glass glue, AB glue, foam glue, all-purpose adhesive, sponge rubber, double-sided adhesive, chloroform, structural adhesive, etc. According to the different material and foundation, the use of the length of time, the difference of installation environment, indoor and outdoor wet, temperature and other conditions to choose the appropriate adhesive. 2, hanging with stationary for some ruffled, large volume, weight is heavier, with foam filling paste can't install adopted by the way. First determine punch points, with the impact drill holes, nail glue and self tapping screw, only one screw, must be located along the punch on the identity, to maintain the level, and then identifies the hem on the screw, adjust the position after the seal around the glass glue can be fixed. 3, prosthesis hanging it is also used in some ruffled logo paste, such as the wall is based on marble, glass, stainless steel and so on are not allowed to punch, and is strong smooth, suit to use this way. First measured position, or Angle of edge with AB glue organic material such as aluminum stick on the wall, hang up and then identifies the ruffled, trimming position, use the glass glue to fixup. 4, hanging the chain hoist material basically has adopted by the iron chain, wire rope, hanging fish wire, cable tie, etc. , according to indoor and outdoor environment, signs of weight, and other special requirements using appropriate hoisting materials. Membrane switch manufacturer introduce installed several ways of sign 5, la explosion screw stationary, this applies to the ground foundation for concrete structure id does not need to move, such as street, parking lot CARDS in this way. 6, the landfill type applies to the ground to the soil structure, does not need to move, according to the size of the logo, high and low, determine how much, dig a hole size using concrete construction should pay attention to the surrounding environment, identify the landfill, must clean up the scene, and water the plants if I restore shall not be damaged. 7, according to the design requirements on floor, place the logo in the corresponding location. 8, decorative screws fixed this way is well designed, the design draft has been clearly identified, such as acrylic powder painting more commonly adopt the way, is mainly must be accurate positioning screw, you can't get installed correctly.
Custom message
Chat Online
Chat Online
Chat Online inputting...
Joey
Joey
Echo
Echo
Alen.Chen
Alen.Chen
Sign in with: