metal pin badges How to Hammer a Hardwall Hanger

The hard wall hanger is a plastic hook with a metal pin on the top that goes through the surface of the wall.They generally support objects that do not exceed 20 pounds, and these objects must be pulled down only, rather than away from the walls.Hangers are suitable for concrete, plaster, brick or hardwood floor walls.
The installation of plastic hardware hooks only needs to position them properly and then hammer the metal nails into the wall.Keep the object hanging on the wall still and move it to the desired installation position.Place the height of the Carpenter on top of the object to make sure it is horizontal and adjust as needed.
Draw a shallow horizontal line above the object to help re-hang it later.View the back of the object, locate the hook, wire, or hook, and measure the distance from the top of the object.Measure the same distance as the Wall mark and draw a small point.
Put the object aside and pick up a plastic hard wall hanger.Turn it so that the hook is facing you and the metal pin is located at the top of the hanger.Place the hook up to the wall and slide the hook part over the point on the wall.
Put the bottom of the hook firmly against the wall with one hand.Pick up the hammer with another hand, hit the metal pins on the top firmly with a hit or two, and insert them into the wall.Hit all pins at the same time with a hammer head.
Stop once the pin is fully plugged in.
Hang the object on a hard wall hanging hook by aligning the top edge with the horizontal line to make sure it hangs evenly