stainless steel label How to Install a Stainless Steel Undermount Sink in Granite Countertop

A stainless-The installation sink under Steel adds a final grade to the granite countertop, and although the work of installing the sink seems difficult, it is not more difficult than installing the traditional sink.However, the installation is only as safe as the glue you use, so it is worth using the two strongest glueYou can find some epoxy cement.Another key to proper installation is to take a moment.Give the glue more curing time than specified on the label, so that when you fill the sink there is no danger of adhesive breakage.Clean the underside of the counter with a rag to remove the dust that may be left over during the cutting hole.Fine granite dust can weaken the bonding of epoxy glue.Place a generous silicone caulking bead around the flat part of the edge of the sink with a caulking gun.Place a two-by-The four pass through the sink opening, parallel to the direction of the counter.Place the bar clip on the wood and put it into the sink hole, then lean the sink against the bottom of the counter and adjust the clip to secure it in place.If the sink has two holes, use two clips.Center the sink and tighten the clip to keep it tight enough to prevent it from moving.Use two glue to stick the Bolt column attached to the sink under the counter around the edgePart epoxy glue.When the glue is set, fix the column in place using masking tape.Let the glue set for the night.Attach the sink to the pillar with the fasteners attached to the bolt pillar.There are different styles, but most people have nuts and you tighten them to the spot with a wrench.Remove the fixture when the fastener is firm.